Dorman 989-714 Instrucciones De Programacion

989-714
IGNITION LOCK
CYLINDER
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
989-714_Tech-Note
CAUTION: Prior to attempting programming,
it is necessary to have at least one functioning
original PATS key (not a duplicate). Before
installing programmer, perform the following
diagnostic test. With new ignition cylinder
installed, hold original PATS key to steering
column near ignition lock cylinder. At the same
time, attempt to start vehicle. If vehicle does not
start, starts and turns off, or theft light flashes,
vehicle will not enter programming mode
and programming using the onboard method
described in these instructions will not be
possible. A suitable scan tool will be necessary
for programming new key(s) to vehicle.
NOTE: This lock cylinder kit consists of an
ignition lock with keys and a programming
tool. There are three keys provided in this kit:
two transponder security keys and one non-
transponder key. The two transponder keys will
need to be programmed to the vehicle. Once
ignition lock cylinder is installed, new keys will
need to be programmed using the following key
programming instructions.
NOTE: Due to programming process being
sensitive to voltage drops, it is recommended
that a battery charger be used while
programming.
NOTE: Programmer works with included keys
only. The tool permits a maximum of four
pairing attempts.
KEY PROGRAMMING
INSTRUCTIONS
STEP 1:
Plug programmer into OBD-II port and wait for
programmer to beep.
STEP 2:
Insert non-transponder key into new lock while
simultaneously holding original key up against lock.
Turn key to ON position without starting and wait for
programmer to beep.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 2 (CONT.):
NOTE: After Step 2, move original key at least
one foot from vehicle to avoid a programming
failure.
STEP 3:
Insert first transponder key. Turn to ON position but do
not start vehicle. Wait for programmer to beep.
STEP 4:
Programmer will begin 10 minute security access check.
LED light on programmer will flash quickly during this
time.
STEP 5:
Programmer will beep twice when security access is
attained. LED light on programmer will flash slowly at
this time.
STEP 6:
Immediately cycle key to OFF to ON and back to OFF.
STEP 7:
Remove key from ignition.
STEP 8:
Wait 90 seconds until programmer beeps twice.
STEP 9:
Reinsert first new transponder key and turn to ON.
STEP 10:
Programmer will beep once to signal first key has been
programmed.
STEP 11:
Remove key from ignition.
STEP 12:
Insert second new transponder key and turn to ON.
STEP 13:
Programmer will beep three times to signal
programming is complete.
STEP 14:
Unplug programmer. Key programming is now complete.
PAGE 1 OF 3