Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
DANGER: Disconnect power before servicing.
wiring must be done in accordance with local codes and/or in Canada with the current CSA C22.1
Canadian Electrical Code, and for US installations, the National Electrical Code ANSI/NFPA NO 70.
WARNING: If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
GLASS INFORMATION
1. Under no circumstances should this product be operated with a broken or chipped glass panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleansers to clean the glass. Make sure the glass is cool to the touch.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done
MAINTENANCE OF MOTORS
1. Always disconnect the appliance from the main power supply and allow it to cool before any servicing
operation.
2.
intake and exhaust, as well as the fan heater is reccomended. For heavy or continous use, periodic
and fan replaced immiediately in order to prevent further damage to the unit.
REMOTE CONTROL INFORMATION
The infrared remote control relies on a line of sight and must be
power and the heater. If you prefer to use the touchpad control on
the touchpad buttons. The layout of the buttons on touchpads and
remote control unit can be seen on the previous page.
8
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull Tab)
Publicidad
