Publicidad
Idiomas disponibles
Idiomas disponibles
Key
Description
A
Air hose
B
In-line Filter
C
Tee Fitting
To begin using the tool:
1.
As a standard practice, drain water from the air
compressor tank and air lines prior to use each day
(reference your compressor operators manual for
detailed instructions).
2.
Install a 1/4" NPT male connector into the air inlet port
on the tool (see Figure 2). Note: Use Teflon® Tape on
all threaded connections.
3.
Turn on the air compressor and allow it to build up
pressure.
4.
Adjust the air compressor's regulator or the supply line
regulator to 90 PSI.
5.
Assemble the selected chisel to the air hammer (see
Figure 3);
a.
Insert the selected chisel into the quick-change
chisel retainer (see A).
b.
Pull back the quick-change chisel retainer and
push in the chisel (see B).
c.
Release the retainer to lock the chisel into place
(see C). Note: the chisels are normal wear items
and should be replaced when worn.
If the chisel is not securely held in place by the quick-change chisel retainer, the chisel
may come loose and cause severe personal injury.
6.
Connect the tool to the air hose quick coupler. NOTE: It is recommended that a whip hose with a swivel
(not included) be used to prevent twisting, kinking and excessive wear to the air hose (ref. item "F"
in figure 1 for recommended connections).
7.
Hold the air hammer in an operating position against the work (with chisel properly secured in place) before
depressing the trigger. Squeeze the trigger gently as required to increase or decrease air hammer speed.
Release trigger to stop tool.
Chisel MUST be held firmly against the work surface before depressing the air hammer
trigger. If the tool is not properly positioned against the work and/or the chisel is not
properly secured in the tool before the trigger is depressed, damage to the tool and/or
the retainer may result. Regulate the speed of the air hammer to control the chisel from
being driven from the cylinder. Internal damage will result if the piston strikes the
cylinder wall. Remove chisel from tool when not in use.
TYPICAL
TYPICAL
Key
Description
D
In-line Oiler
E
Air Hose
F
Whip Hose
OPERA
TING INSTRUCTIONS
OPERA
TING INSTRUCTIONS
INST
ALLA
TION
INST
ALLA
TION
Key
Description
G
Quick Coupler
H
Male Connector
I
Air Tool
Figure 2
Figure 3
4 - ENG
Figure 1
Key
Description
J
Female Connector
K
Spray Gun
Publicidad
