Panasonic Viera TC-P42G15 Guia De Inicio Rapido página 45

Check that the network settings are as shown below, and then start "Connection test".
Select "Connection test" and press OK.
*Press OK again to cancel the test.
(It takes a while to cancel the test.)
Network setting 1/2
Connection test Succeeded
IP setting mode Manual
IP address 192.168.0.5
Subnet mask 255.255.255.0
Default gateway 192.168.0.254
Select "IP setting mode" and set to "Automatic".
(When IP automatic acquisition in DHCP can be used)
Network setting 1/2
Connection test Succeeded
IP setting mode Automatic
IP address 192.168.0.5
Subnet mask 255.255.255.0
Default gateway 192.168.0.254
The acquired address is displayed.
Each IP address is acquired automatically.
Select "DNS setting mode" and set to "Automatic".
(When DNS automatic acquisition in DHCP can be used)
Network setting 1/2
Connection test Succeeded
Default gateway 192.168.0.254
IP setting mode Automatic
DNS setting mode Automatic OK
Primary DNS 192.168.0.20
Secondary DNS 192.168.0.21
The acquired address is displayed.
Each IP address is acquired automatically.
If you are using a broadband router, IP automatic
acquisition in DHCP can be used under normal
circumstances. If you are not sure, check with the
person who installed the equipment, or check the
instructions for each device.
Select "LAN speed setting" (Default is "Automatic")
Network setting 2/2
LAN speed setting Automatic
LAN speed 10BASE half duplex
Software update
MAC address 12-34-56-78-80-ab
Select "Software update"
Network setting 2/2
LAN speed setting Automatic OK
LAN speed 10BASE half duplex
Software update
MAC address 12-34-56-78-80-ab
The network settings become effective when you close the menu and run "Connection test".
All manuals and user guides at all-guides.com
Succeeded: "Connection test" succeeded
Only home network:
Failed: Check the broadband environment connection
select
Test in progress
ok
---:
■
select
ok
■
select
ok
select
adjust
select
ok
Home network is available.
and settings and the network settings, and then
perform the test again.
Test not yet performed
Manual setting
Select "IP setting mode" and set to "Manual"
Select the item and press OK
Check the specifications of the broadband router and
enter each IP address.
Subnet mask 10I 0 . 0 . OK
or
Manual setting
Select "DNS setting mode" and set to "Manual"
Select the item and press OK
Enter each IP address as was specified by the
provider.
Primary DNS 10I 0 . 0 .
or
Normally, select "Automatic".
If "Connection test" failed, set the "LAN speed setting"
to "manual" and then select "10BASE half duplex",
"10BASE duplex", "100BASE half duplex" or "100 BASE
duplex".
Cannot be selected when the "LAN speed setting" is
"Automatic".
Changing the settings may make it impossible to
connect some types of equipment.
Press OK to start the software update screen.
Follow directions of the screen.
* Set "Clock" first. (p. 18)
0 . 0
change
channel
ok
0 . 0
select
ok
45