Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE FEET
See Figure 4.
- Locate the following items:
Foot bracket
2 lock nuts
2 bolts
- Insert bolts through the foot bracket and holes in
the generator frame as shown.
- Thread lock nuts onto bolts and tighten one full
turn past snug.
NOTE: Be careful not to overtighten so that foot
material collapses.
INSTALLING THE WHEELS
See Figure 5.
Wheels are provided to assist in moving the gene-
rator to the desired location and should be insta-
lled on the same side as the handle.
- Locate the following items:
2 axles
2 hitch pins
2 washers
2 wheels
- Raise the end of the generator where the handle
is located high enough to gain access to the frame
bottom; securely position props underneath to
support.
-
Slide the axle through the hole in the center of the
wheel.
- Slide a washer onto the axle, then slide the axle
into the
wheel mounting hole as shown.
- Insert hitch pin to secure.
NOTE: The hitch pin should be pushed into the axle
until the center of the pin rests on top of the axle.
- Repeat with the second wheel.
CONNECTING/DISCONNECTING BATTERY
See Figure 6.
www.ducsonpower.com
WARNING:
To reduce the risk of electrocution or explosion, do
not short circuit the battery terminals or charge in a
sealed container. Keep sparks and flame away.
WARNING:
Keep metal objects away from the battery terminals.
Metal objects can make a connection from one
terminal
to another. Shorting the battery terminals together
can cause sparks, burns, or a fire.
NOTICE:
The battery may require charging before the gene-
rator can be started using either the engine switch or
the recoil
starter. Once the generator is started, the battery will
charge as the unit runs. The battery cables must be
connected before the generator can be operated.
To connect battery cables:
- Connect the red wires to the positive (+) terminal
first, then connect the black wire to the negative (-)
terminal. Make sure all connections are tight.
NOTE: Be careful not to short across the terminals
when
installing. Shorting the terminals together can cause
sparks, damage to the battery or generator, or even
burns or explosions.
- Cover the terminals with the rubber covers.
When removing the battery for replacement:
disconnect the negative (black) post, then the positi-
ve (red) post, being careful not to short across the
terminals. Always abide by the safety warnings
provided with the battery. Remove the battery and
dispose of according to local and state regulations.
DANGER:
Carbon Monoxide. Using a generator indoors CAN
KILL YOU IN MINUTES.
Generator exhaust contains high levels of carbon
monoxide (CO), a poisonous gas you cannot see or
smell. If you can smell the generator exhaust, you
are breathing CO. But even if you cannot smell the
exhaust, you could be breathing CO.
Pag: 15
Publicidad
