Installation Precautions; Dimensions (Mm) - urmet domus 1092/122 Manual De Usuario

INSTALLATION PRECAUTIONS


Never install the CCTV camera where it is exposed to rain or moisture. In these cases, use the
specific housings.

When the CCTV camera is used in variable lighting conditions, an Auto-Iris lens must be used.

To prevent device overheating, place it in a well aired position.

For the same reason, the device must not be installed near heat sources as radiators or warm air
ducts, in places where it is directly exposed to sun irradiation or in rooms with excessive dust
accumulation, subject to mechanical vibrations or impacts.

Consider the device operating temperature range (-10°C÷+50°C) before choosing the place for
installation. Do not install the unit over another heating device.

Do not power the device on immediately after moving it from a cold place to a warm one and vice
versa. As a general rule, wait for three hours: the device needs this time to adapt to a new
environment (temperature, humidity, etc.).

DIMENSIONS (mm)

INSTALLATION
1 Make sure that no units are powered before starting the installation procedure.
2 Remove the CCD cover.
3 Fit the lens on the camera.
4 Connect the wire to the AUTO-IRIS connector .
5 Connect the CCTV camera to the other devices of the system using an approved 75 ohm coax cable.
6 Power the mini camera.
7 Make the adjustments required (see paragraph below)
AUTO-IRIS PLUG
Auto-Iris plug PIN definition
PIN DC
1 DAMP (-)
2 DAMP (+)
3 DRIVER (+)
4 DRIVER (-)
10
1 3
2 4
Upper side
Lower side
DS1092-073