Assembly; Parts You Will Receive; How To Assemble Your Sprayer - Swissmex MX Serie Manual De Operador

3.3 ASSEMBLY

3.2.1 Parts you will receive

- 1 Pump handle
- 1 Pump lever
- 1 Spray wand
- 1 Tank lid
- 1 Owner's manual
Inside the tank you will find:
- 1 Strainer
- 1 Bushing guide
- 1 Felt ring
- 1 Pump tube with hose and shut-off valve
- 1 Agitator
And a plastic bag with:
- 1 washer
- 1 "R" lock pin
- 3 washers and 3 "c" lock pin
- 1 Adjustable nozzle

3.3.2 How to assemble your sprayer:

Following is explained how to assemble your sprayer, read carefully the text. The number at the beginning of the line corresponds to the
graphic.
1. Take out all the parts from the box and from the tank.
2. Place the sprayer vertically on a table, place the pump holder nut, gasket and felt ring on the side mouth. Oil the piston sleeve and the pump tube,
insert it in the pump tube guide; carefully directing the piston sleeve to avoid any damage.
3. Tighten the pump holder nut. Place the agitator.
4. Place the strainer and the tank lid on the tank opening.
5. Insert the connecting rod in the pump tube placing one flat washer on each side, fix them with the lock pins "C".
6. Pass the pump handle through the base of the tank fixing it to the connecting rod with a flat washer and a lock pin "C" and on the other end with a lock
washer and a cotter pin.
7. Finally tighten the spray gun and tube.
1
4
6
MODEL: 189185 MX07
289185 MX08
6
MODEL:
081185 MX05
101185 MX06
2
5
081185 189185
MX05 MX07
101185 289185
MX06 MX08
model
model
MX 06
MX 05
3
models
MX 07
MX 08
MX07
MX08
3
MX05
MX06