Publicidad
Idiomas disponibles
Idiomas disponibles
Shortcut installation operation:
Connect this unit and other equipments related according to "BASIC CONNECTION":
1. Turn on the POWER switch, then the unit shall get to DVB-T status automatically.
2. Press MENU button to enter the TV Menu, then use
button to confirm autoscan of TV programs, when a information bar shall indicate the progress of
autoscan from the very beginning to the end by percentage of completeness.
3. Press EXIT to retreat from the menu interface. Use
4. Pressing EXIT long enough (over 2 seconds) shall enable to switch between TV state and DVB-T
state.
5. In DVB-T state, press MENU to enter the DVB-T Menu. If this unit is used for the first time or the
software has just been undated, you shall have to get to the SETUP menu, then choose Factory
Restore before pressing OK to confirm the operation.
6. Enter into the SCAN menu, and choose AUTO SCAN in Scan Type options, then press OK to start
Auto-scan operation.
7. After scan, exit from the main menu, then press OK to pop up the Service List, and use
to choose a program service before pressing OK again to enjoy DVB-T programs.
Read the following instruction for details about particular operation.
Menu operation:
Section 1: TV Menu operation
1. TV Menu
Press MENU button to enter the TV Menu interface where there are 6 option items available:
BRIGHTNESS
CONTRAST
AUTOSCAN
MANUALSCAN
ADJUST FRE
PROGRAM TABLE
At the bottom of the screen, there exists a status bar indicating the current working status and
operation tips.
2. BRIGHTNESS
Select the submenu of BRIGHTNESS, where the
status bar indicates BRIGHTNESS ADJUST, and
use the
button to conduct the adjustment of
brightness whose range is 1-60.
Note: Adjustment of brightness shall impact only
the TV program instead of the OSD and DVB-T
menu and programs.
3. CONTRAST
If choose Contrast item, the status bar shall show
'CONTRAST ADJUST', then you can adjust the
c ontr as t of di sp lay whi ch i s w ithi n 1-6 0
with
button.
Note: Adjustment of brightness shall impact only
the TV program instead of the OSD and DVB-T
menu and programs.
4. AUTOSCAN
Select AUTOSCAN submenu, the status bar
shows 'AUTO SCAN PRESS OK KEY', then press
OK to start auto scan with the status bar indicating
'AUTO SCANNING' and the scan progress bar
indicating the process from 1% to 100% of
completeness.
As soon as a TV program is scanned, it shall be
automatically played for two seconds, and get
back to the first scanned program to start playing
with. The status bar shows AUTO SCANNED.
Bmt-76.p65
Operation
-32-
32
button to select AUTOSCAN, and push OK
button to select a channel and enjoy it.
06-4-10, 19:33
button
Publicidad
