Cherubini A520018 WindTec Instrucciones página 23

The wind level point can be set using the button provided in the lower part of the WindTec
sensor, identified by the windsock symbol. The speed can be set from a minimum of 7,5
Km/h to a maximum of 45 Km/h.
It's prudent not to set the wind speed over the fourth level, which corresponds
to 35 Km/h.
"WIND-SPEED"
SETTING.
Following a wind alarm, the motor closes automatically the awning, overriding user
commands until the wind alarm passes. To deactivate the wind alarm, it's necessary that
the wind speed remains below the set level for at least 8 minutes. After these 8 minutes
the awning returns to the position it was in before the alarm, if the automatic reopening
function is active. This pause time is included to ensure awning protection and to prevent
continuous motor movement in the event of sporadic gusts of wind.
With the automatic reopening system, at the end of the wind alarm, the awning opens
again. From factory this function is not activated in the Blue Wave RX motor, but can be
easily activated with the following command sequence:
Tn: Already programmed remote control
+
A B
Tn
SETTING THE WIND SENSOR
ACTIVATING AUTOMATIC REOPENING
- only with Blue Wave RX motors -
MAXIMUM RECOMMENDED SPEED
FOR THE WIND-ALARM (35 km/h)
C
Tn
23
C
Tn (2 sec)