Cherubini A520018 WindTec Instrucciones página 26

This function is useful to check the correct communication via radio, and to perform the
wind and sun function test.
To activate the TEST function, hold the SET button down for around 2 seconds, until
the motor confirms the command by bringing the awning to half opening distance. The
test function lasts for 3 minutes, during which the wind and light level settings can be
checked, without waiting for the activation times. After 3 minutes, the WindTec sensor
returns to normal mode function.
WIND FUNCTION TEST
To avoid errors during the wind function test, we advise setting the motor to manual mode
(wind only). With the anemometer blades moving, when the speed detected by the sensor
exceeds the set level, the motor will close completely the awning. After the awning is
closed and the anemometer blades stop turning, the awning returns to halfway out if the
automatic reopening function is active; if it is not, the awning remains closed.
SUN FUNCTION TEST (WindTec Lux)
Check that the motor is set to the automatic mode. When the sensor detects a change in
light intensity, it opens the awning if brighter than the set point or closes it if weaker. This
test can be repeated several times to establish the desired automatic opening and closing
level according to the light.
DECLARATION OF CONFORMITY
Company CHERUBINI S.p.A. situated in via Adige, 55 25081 Bedizzole (BS) ITALY, declares under its sole responsibility
that products WindTec and WindTec Lux conform to the essential Safety and Electromagnetic Compatibility
requirements of the UE Directives:
Directive 2014/35/EU safety of electrical equipment LVD, Directive 2014/30/EU on the approximation of the laws
of the Member States relating to electromagnetic compatibility EMC, Directive 1995/5/EC on radio equipment and
telecommunications terminal equipment RTTE.
This declaration becomes void if the unit is modified without Cherubini S.p.A. approval.
Harmonized Standards applied: EN 60950, EN 62479
I
TEST MODE
Set button
ETSI EN 301-489-1, ETSI EN 301-489-3
ETSI EN 300 220-1, ETSI EN 300 220-1
set
(2 sec)
26