RANGEFUL Lance 200 PRO Manual De Instalación página 8

3.3. Manual Gain Control (MGC)
Press « SET », wait till you reach to the uplink gain (the uplink gain
figure is flickering), then press «
gain as per the request, Please do remember to press «
again to confirm the right settings.
Repeat the steps for setting the downlink gain.
3.4. Smart function
The Smart function means that the repeater could set the gain
automatically. Press «
ATTENTION!
set the gain manually. Disable the smart function if you need to
set the gain manually, and follow the instruction of MGC setting.
4. Installation
4.1. General conditions
First, assemble the mobile signal amplification system. Use the
following additional equipment:
•
An outdoor antenna that will provide communication between
he repeater and base stations of mobile operator.
•
An indoor antenna or several antennas that will provide
communication between the repeater and mobile devices.
•
Coaxial cable (50 Ohm) and connectors (N-type or SMA
according to the antennas used) for connecting antennas to the
repeater.
8 8
SMART » to turn enable this function.
When the smart function is enabled, users can't
MGC » to decrease /increase the
SET »