Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3. Finishing the Motor Connection
1. Tuck connections neatly into ceiling outlet box.
2. Slide the canopy up to hanger bracket and place the key
hole on the canopy over the screw on the hanger bracket,
turn canopy until it locks in place at the narrow section of
the key holes. (Fig. 9)
3. Align the circular hole on canopy with the remaining hole
on the hanger bracket, secure by tightening the two
set screws. Note: Adjust the canopy screws as necessary
until the canopy and canopy cover are snug.
WARNING:
Make
bracket is properly seated in groove of hanger ball before
attaching canopy to bracket. Failure to properly seat tab in
groove could cause damage to electrical wiring.
Step 4. Attaching the Blades
CAUTION: Remove 5 rubber packing mounts
and discard before installation.
1. Attach the blade to the blade bracket
using the screws and rubber washers as
shown in Figure 10. Start screw into bracket,
do not tighten. Repeat for the two remaining
screws.
2. Tighten each screw. Make sure the
blade is straight.
3. Fasten blade assembly to motor using the
screws supplied. (Fig. 10)
sure
tab
at
bottom
Outlet box
Hanger
bracket
of
hanger
Screws
6
Figure 9
Screws and
rubber washers
Blade
Blades bracket
Figure 10
Screws
Canopy
Canopy cover
Publicidad
