Sauder Briarbrook Serie Instrucciones De Montaje página 33

Step 28 Step
å
Place your Hutch along the back edge of the 429446 Desk as shown.
å
Fasten the BRACKETS (M) to the 429446 as shown. Tighten four 1/2" HEX HEAD SCREWS (15)
using the L-WRENCH (6).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Fasten the Hutch FRAMES (O and P) to the BRACKETS (M). Use four 3/8" HEX HEAD
SCREWS (17) through the holes in the Hutch FRAMES and BRACKETS, then tighten four NUTS (9) onto
the 3/8" HEX HEAD SCREWS using the WRENCHES (6 and 12) as shown in the enlarged diagram.
Hey! It's starting to look
like something!
17
6
430077
O
9
12
M
3/8" HEX HEAD SCREW
(4 used in this step)
www.sauder.com/service
1/2" HEX HEAD SCREW
(4 used in this step)
17
P
M
15
Page 33