Sauder Clifford Place Serie Instrucciones De Montaje página 10

Step 5
å
Separate the EXTENSION SLIDES (Q) from the EXTENSION RAILS (P) as shown in the enlarged
diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (P) to the ENDS (A and B). Use six 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram.
Then, slide the inner cartridge of the EXTENSION RAIL in to find the other holes that lines up with
the holes in the ENDS. Turn a SCREW into those holes.
å
NOTE: The EXTENSION SLIDES (Q) will be used later for the DRAWERS.
Use these holes.
Page 10
P
Pull down on the black release lever and pull the SLIDE from the RAIL.
P
B
Open end
www.sauder.com/service
Q
1/2" PAN HEAD SCREW
(6 used in this step)
A
P
7
20
Open end
P
433364