Publicidad
Idiomas disponibles
Idiomas disponibles
4
Installation
4.1 Mounting
4.1.1 Mounting location
Ensure that the mounting location satisfies the following requirements:
Mount in a dry, dust-free indoor room.
Mount on even surface.
Mount upright on the wall, on concrete or on any other non-flammable
surface.
The mounting location must be protected from unauthorized access, espe-
cially by small children.
Distance between inverter and battery: please note that the pre-fitted cables
must not be extended.
Minimum clearance of approx. 20 cm above and below to allow free air circu-
lation.
4.1.2 Mounting the inverter
Mark and drill the upper holes (Ø 8 mm).
Insert the dowels and screw in the screws. Do not yet screw tight!
Hang the inverter on the two screws and mark the lower holes.
Remove the inverter and drill the two lower holes.
Insert the dowels.
Hang the inverter on the two upper screws and screw in the lower screws.
Screw all screws tight.
The mounting of the inverter is now complete.
20
EN
191
191
746.489 | 12.41
Fuse
190,23
Fuse
Fuse
-
-
+
+
+
-
+
191
190,23
-
+
Netz
-
+
Netz
Netz
-
190,2
Publicidad
