Publicidad
Installation in a LAN (IP Address Assignment)
Automatic IP address assignment via ZeroConf
Once the TPG120 is connected to the network, it checks whether an IP address
can be obtained from boot protocols DHCP or BOOTP. If this is not the case, the
TPG120 assigns itself an IP address via ZeroConf. This IP address is taken from the
address range 169.254.0.0/16; which is reserved for ZeroConf.
If you wish to use an IP address different from the one assigned via ZeroConf,
you can assign an IP address to the TPG120 in many ways.
This document describes the assignment of IP addresses via the IP Wizard in the
InterCon-NetTool. Additional methods are described in the 'TPG User Manual'.
IP address assignment via the InterCon-NetTool (IP Wizard)
The software InterCon-NetTool has been developed by SEH Computertechnik
GmbH for the administration of SEH network devices within a predefined
network.
The IP Wizard is integrated into the InterCon-NetTool. The IP Wizard helps you to
configure TCP/IP parameters, e.g. the IP address. You can choose between the
manual configuration and the automatic configuration via boot protocols.
Saving the IP address via the InterCon-NetTool in networks with routers is only
possible if the router forwards multicast requests and if network devices are
searched for via multicast.
Proceed as follows:
1. Install the InterCon-NetTool on your client; see the 'TPG User Manual'.
2. Start the InterCon-NetTool; see the 'TPG User Manual'.
3. Mark the TPG120 in the print server list. (You will find the TPG120 under
'ZeroConf'.)
4. Select Installation - IP Wizard from the menu bar.
5. Follow the instructions of the IP Wizard.
The settings are saved.
14
Quick Installation Guide
Publicidad
