KPS DT100 Manual De Instrucciones página 3

AC VOLTAGE DETECTOR
WARNING: BE EXTREMELY CAREFULIN THE USE OF
THIS DEVICE.
Improper use of this device can result in injury or death.
Follow all safeguards suggested in this manual in addition
to the normal safety precautions used in working with
electrical circuits. DO NOT service this device if you are
not qualified to do so.
SAFETY SYMBOLS
Important safety information, refer to the operating
manual.
Double insulation (Protection class II)
Earth ground
SPECIFICATIONS
Voltage Sensitivity 90 to 1000V AC
Frequency 50/60Hz
Detection distance <5mm
Over voltage CAT II 1000V CAT III 600V
Battery 2x1.5V AAA
Safety For indoor use and in accordance
with Over voltage Category III 600V
Pollution Degree 2.
BATTERY INSTALLATION
1. Open the battery door (end cap) by gently prying
up/out at the pocket clip using a small
screwdriver.
2. Insert two AAA batteries (observe polarity).
3. Replace the battery door
OPERATING INSTRUCTIONS
WARNING: Risk of Electrocution. Before using to
check for voltage in an outlet, always test the
Voltage Detector on a known live circuit to verify
that the Voltage Detector is working properly.
WARNING: Risk of Electrocution. Keep hands and
fingers on the body of the probe and away from the
probe tip.
To check AC electrical voltage in an outlet:
1. Touch the probe tip to a cord plugged into the
outlet, or insert it into the outlet hole.
2. If AC electrical voltage is present, the detector
light will flash and the audible warning will
sound.