Descargar Imprimir esta página

DeWalt DCMWP600 Manual De Instrucciones página 21

Publicidad

Idiomas disponibles

Idiomas disponibles

Blade Reset Button (Fig. U)
nOTE: Ensure the battery pack 
are installed before attempting to reset.
To clear the blade sharpening indicator
the LED dashboard
12
by pulling and holding the
bail handle 
 8 
to the main handle 
the blade reset button 
17
indicator 
 16 
 turns off.
Starting Mower (Fig. Q—T)

DANGER: Sharp moving blade. Never attempt
to override the operation of the switch box and
safety key system as serious injury could result.

WARNING: Ensure self drive is disengaged before
starting the mower.
nOTE: Mower is operational when the battery pack 
safety key 
6
are installed.
1. Lift and hold the battery port cover 
battery port 
 38 
.
2. Slide a battery pack 
 26 
audible click is heard.
nOTE: Ensure the battery pack is fully seated and fully
latched into position before starting mower.
3. Close the battery port cover  
cover 
 19 
is fully closed before starting the mower.
4. Insert safety key 
6
into the key slot 
the main handle
4
, until it is fully seated inside of the
key slot 
 50 
as shown in Fig. T.
5. To power on the LED dashboard
bail handle 
 8 
to the main handle 
6. To start the mower blades, continue to hold the bail
handle 
 8 
to the main handle 
power button 
 11 
.
nOTE: Once the mower starts you can release the
power button 
 11 
, but you must continue to hold the
bail handle 
 8 
to the main handle 
to stay running.
7. To turn the mower OFF, release the bail handle 

WARNING: Never attempt to lock a switch or bail
handle in the ON position.
nOTE: Once the bail handle 
position it will activate the "Automatic Braking Mechanism. "
The motor is braked and the mower blades will stop rotating
in three seconds or less. If mower blades rotate longer than
three seconds, discontinue using mower and have it serviced.
 26 
and safety key 
6
16
, power on
 4 
. Press and hold
until the blade sharpening
 19 
up to expose the
into the battery port
38
 19 
. Ensure the battery port
 50 
, located on
12
, pull and hold the
 4 
.
 4 
and then press the
 4 
for the mower
 8 
 8 
has returned to the original
DCMWSP650 ONLY
Self Drive System (Fig. V)

DANGER: Sharp moving blade. Never attempt to
override the operation of the switch box, the self
drive system or the safety key system as serious
injury could result.
Your mower DCMWSP650 is equipped with a self drive system
which functions independently of the mower blades.
1. To use self drive, press the self drive lever
main handle 
2. To turn off self drive, release the self drive lever
nOTE: During cutting, at times it may be easier to
maneuver around an object, such as a tree or plants, with
the self drive off. The mower can easily be used with the
self drive system off.
DCMWSP650 ONLY
Speed Adjustment Dial (Fig. W)
 26 
and
Your DCMWSP650 mower is equipped with a speed
adjustment dial 
The numbers on the speed adjustment dial 
quickly or slowly the self drive system propels the mower.
Choosing a lower number propels the mower at a slower
until an
pace. Choosing a higher number propels the mower at a
faster pace.
1. To increase the speed of the self drive system, rotate the
speed adjustment dial 
nOTE: The speed adjustment dial 
higher number.
2. To decrease the speed of the self drive system, rotate the
speed adjustment dial 
nOTE: The speed adjustment dial 
lower number.
Mower Overload
To prevent damage due to overload conditions, do not try to
remove too much grass at one time. Slow down your cutting
pace, or raise the cut height.
Mowing Tips (Fig. A)

WARNING: ALWAYS INSPECT AREA WHERE
.
MOWER IS TO BE USED AND REMOVE ALL STONES,
STICKS, WIRE, BONES, AND OTHER DEBRIS WHICH
MIGHT BE THROWN BY THE ROTATING BLADE.

WARNING: Mow across the face of slopes, never
up‑and‑down. Exercise extreme caution when
changing direction on slopes. Do not mow excessively
steep slopes (greater than 15 degrees). Always
maintain good footing.
Release bail handle
crossing any gravel area (stones can be thrown by
the blades).
Set mower at highest cutting height when mowing in
rough ground or in tall weeds. Removing too much grass
at one time can cause the motor to be overloaded and
to stop.
 4 
.
 10 
located next to the LED dashboard
 10 
towards the rabbit icon
 10 
 10 
towards the turtle icon
 10 
8
to turn mower "OFF" when
English
9
towards the
9
.
12
.
 10 
indicate how
40
.
will display a
41
.
will display a
19

Publicidad

loading

Este manual también es adecuado para:

Dcmwsp650