Publicidad
Idiomas disponibles
Idiomas disponibles
A. No flush-mounting
1) Make a space in your wall large enough to fit the protective cover (Dimensional diagram)
2) Insert the pins into the holes and fix the protective cover using the screws provided.
3) Pass the cable through
4) Connect the screen wire to the outdoor unit. Make sure that the 2 units are correctly connected. (Diagram - 2 units)
5) Before attaching the outdoor unit to the protective cover, connect the wires. Refer to the different diagrams and connect the
one that corresponds to your house (Diagram Lock + Gates - 2 Gates - 2 Lock)
6) Use the screws provided to fix the exterior unit to the protective cover
B. Flush mounting
3.2 7'' Screen
1) Make 4 holes in line with positions shown on the wall bracket.
2) Make a hole in your wall to hide the electrical domino
3) Insert the pins into the holes and fix the wall bracket using the screws provided.
4) Connect the power cable and the outdoor unit wire (to do this you must use a terminal block between the 2 connectors to
connect the screen to the outdoor unit).
5) Place the screen on the wall bracket as described in the picture.
1
1) Make a space in your wall large enough to fit the flush-
mounting box
2) Make 4 holes in line with the position show on the flush-
mounting box (Dimensional diagram)
3) Insert the pins into the holes and fix the flush-mounting box
using the screws provided.
4) Pass the cable through
5) Connect the screen wire to the outdoor unit. Make sure that
the 2 units are correctly connected. (Diagram - 2 units)
6) Before attaching the outdoor unit to the flush-mounting box,
connect the wires. Refer to the different diagrams and connect
the one that corresponds to your house (Diagram Lock +
Gates - 2 Gates - 2 Lock)
7) Use the screws provided to fix the exterior unit to the flush-
mounting box
2
1
2
Publicidad
