Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL
GB
Com Uni 3 Universal remote control
B. Setup of the STB, SAT and TV mode
1. Insert two new 1.5V AAA/LR03 batteries (correct position is indicated at the base
of the battery slot).
2. Switch on your device (to programme the remote control for the TV set, ensure that
the television shows a picture).
etc.
codes for your TV brand.
succession (after approx. 3 seconds).
device.
the code has been accepted by your Com Uni 3 remote control. This does not
necessarily mean it is the correct code for your model of device.
8. Press the standby key to check whether your Com Uni 3 remote control is working
properly. If your TV is thereby not set to standby mode, refer to the next code in the
list and repeat the programming procedure from step 3.
9. If your TV is set to standby check all other functions of the TV. If certain functions
are not available or not working properly, refer to the next code in the list and
repeat the programming procedure from step 3.
To program the STB mode please proceed as described in the programming
instructions for television sets, but instead of "TV" key use the "STB" key as
well as the codes from the STB section.
To program the SAT mode please proceed as described in the programming
instructions for television sets, but instead of "TV" key use the "SAT" key as
well as the codes from the SAT section.
C. Brand code scan
If the listed codes are not working or if the manufacturer of your device is not listed,
you have the option to search for a suitable code by means of the brand code scan.
1. Insert the batteries (correct position is indicated at the base of the battery slot).
2. Switch on your TV set.
succession (after approx. 3 seconds).
4. Within the next 10 seconds enter the code 0 0 3
again.
5. Within the next 10 seconds enter the 3 digit brand code of your device, the green
seconds.
2 seconds, this indicates that the automatic scan is in progress. After the device
has switched off, switch it on again to check the other functions of the device. If all
functions work as desired, press the "OK" key to save the found code.
7. If certain functions are not available or not working properly, repeat the code scan
procedure (steps 2 to 6) until you have found the best code.
6
USER MANUAL
GB
Com Uni 3 Universal remote control
After all saved codes have been scanned by your Com Uni 3 remote control, the red
To start the brand code scan for the STB and SAT mode please proceed as
described in the brand code scan for television sets, but instead of "TV" key use
the "STB" or "SAT" key as well as the brand codes from the STB/SAT section.
D. Complete code scan
code or if the manufacturer of your device is not listed, you have the option to let the
1. Insert the batteries (correct position is indicated at the base of the battery slot).
2. Switch on your TV set.
succession. (after approx. 3 seconds).
the device has switched off. Please consider that the complete code scan can take
indicates that the automatic scan is in progress. After the device has switched off,
switch it on again to check the other functions of the device. If all functions work as
desired, press the "OK" key to save the found code.
6. If certain functions are not available or not working properly, repeat the code scan
procedure (steps 2 to 5) until you have found the best code.
After all saved codes have been scanned by your Com Uni 3 remote control, the red
To start the complete code scan for the STB and SAT mode please proceed as
described in the complete code scan for television sets, but instead of "TV"
key use the "STB" or "SAT" key as well as the brand codes from the STB/SAT
section.
0 0 1, the green
7
Publicidad
