Publicidad
Idiomas disponibles
Idiomas disponibles
RADIO: Connected dimmer for light
control
MTV150EBRP 5454813 Connected dimmer for light control, 1 module
Functions
The module allows you to adjust the light intensity of:
LED lamps, fluorescent lamps, halogen lamps, incandescent lamps,
dimmable electronic transformers for incandescent lamps and transformers
ferromagnetic for incandescent or LED lamps.
This module can be controlled:
- from the button on the device;
- by one or more additional local buttons;
- via radio from remote control;
- remotely via the YnO app.
It is also possible to carry out centralization via radio using the module
cod. 5454815 or via a remote control.
Technical specifications
Mains voltage:
Minimum power:
Maximum power:
Radio frequency band:
Maximum radio power transmitted: 10mW
Ambient temperature:
Relative humidity:
Dimming:
Protections:
Degree of protection:
Dimensions of buttons (W x H):
Dimensions of module (L x H x D): 22,5 x 50 x 50,5 mm
WIRING
The module must be installed only by qualified personnel and into a place the end-user cannot access, according
to the installing national rules. In order to follow the safety rules, the module must be connected to a power line
that is upstream protected by a magnetothermic switch 10A C curve.
With the low voltage light bulbs do not mix the ferromagnetic, electronic and toroidal transformers.
DO NOT INSTALL ON REMOTE CONTROLLED SOCKETS - Installation on remote controlled sockets is risky because
end users could connect any type of electrical load and damage the module as a consequence.
Centralised
RADIO control
Remote control
Optional
E5
L
N
5454815
Optional
DS1054-076
230 V ~ (+10% -15%) - 50Hz
5 W
150 W 0,6 A
2400 - 2480 MHz
from -20°C to +40°C
from 0 to 90%
on sinusoidal at start or end of phase with automatic
load type detection
short-circuit and overheating protections
IP30
22,5 x 45 mm
Optional
pushbuttons
E5
230V ~
max
R1
5454813
L
N
Installing Cautions
P1
P2
RADIO control
E5
150 W
P9
GB
RADIO RANGE:
POWER range:
• inside 100 m² apartments with
perpendicular crossing of main wall
or ceiling
• 250m in open range
(Note: in both cases the range may
be reduced by presence of metallic
elements, crossing of walls or parti-
tions).
RADIO TRANSMISSION
The transmitter LED will light up
only if radio
transmission was successful.
Adding an intermediate receiver
makes it possible to solve a problem
of insufficient range.
Refer to the transmitter instruction
booklet for more information.
CAUTION
Accessory FDVDT (Code
Specific
5454075) must be installed
if the power line of the
module
inductive loads (e.g. window
shutters
ballasts
Remote control
transformers). The accessory
Optional
must be connected as close
as possible to the module in
parallel between live and
neutral.
overvoltage protection of the
module could be rapidly
damaged
accessory. The module must
be installed according to the
rules in force in the country in
which it is sold.
is
shared
with
or
ferromagnetic
or
ferromagnetic
The
internal
without
this
Publicidad
