Pfister Clairmont LF 534 Serie Manual Del Usuario página 4

11
Water Supply Lines are not included. Please
consult manufacturer and/or its instructions
for the correct method of installation of supply
lines and fittings.
CAUTION: Incorrect application of supply
lines and fittings may result in the failure or
leak of the supply lines and fittings.
B
11C
1" Max.
(26 mm)
Red Tag
11A
11B
HOT
C
11D
11E
11B
11 WATER SUPPLY CONNECTIONS
A. Thread Inlet Connectors (11A) into Water Supply Lines (11B).
B. Remove Protective Cap (11F). Gently separate hot and cold Faucet Inlets (11C),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (11B) onto Faucet Inlets
(11C). Hot water supply line goes to hot inlet fitting indicated by red tag.
C. Insert Clip (11D) into Inlet Connector Holes (11E) to secure water supply lines, as shown.
A
11A
11B
11C
11C
11C
11F
COLD
11A
11D
11B
ENGLISH
12
12C
12A
12 PULL-OUT HOSE ATTACHMENT
From underneath sink, remove Protective Cap (12E). Push Quick Connector (12A),
located on the end of the Pull-Out Hose (12B) firmly upward onto the Receiving Tube
(12C), until unable to push any further. Pull down on the Quick Connector (12A). If the
housing and the Inner Collect (12D) separate slightly but do not pull off, the Receiving
Tube (12C) quick connect is secure.
13
13 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
14
14 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may have collected
in the water lines, it will be necessary to flush the faucet. Lift the faucet handle (14A)
up to the full on position. Run water for one minute. Repeat in hot and cold positions.
Note: For valve functions (see step 17).
4
12C
12D
12A
14A
12C
12C