Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Preparing the crossbar assembly
□
Unscrew the two mounting balls (1) from the fixture body (A).
□
Remove the crossbar assembly (AA) from the fixture body (A) and
keep the crossbar assembly (AA) and two mounting balls (1) for
later use.
□
Unscrew the lock ball (2) from the fixture body (A).
□
Rotate the flat scroll to the top of the fixture. Place the mounting
hole of the flat scroll onto the nipple.
□
Secure with the previously removed lock ball (2).
AA
3
Test fitting backplate on the fixture body to the crossbar assembly
□
Fit the backplate on the fixture body (A) to the crossbar assembly (AA) and secure with the mounting balls (1).
*If this does not work, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled
hex nuts.
*Then, screw the mounting screws in or out of the crossbar assembly (AA) until the desired length is achieved.
□
Once the backplate on the fixture body (A) is secure, remove the mounting balls (1) and fixture body (A) and proceed to Step 4.
1
NOTE: The backplate on the fixture body (A) should be snug against the wall and
the mounting balls (1).
AA
2
Installing the crossbar assembly
□
Secure the crossbar assembly (AA) to the outlet box (not
included) with the outlet box screws (BB). Tighten until snug.
2
5
NOTE: Prior to installation, close or cover the sink
drain and/or any vents near the installation site to
prevent loss of mounting hardware if dropped.
NOTE: The preassembled mounting screws on
the crossbar should protrude outward.
1
A
Please contact 1-855-HD-HAMPTON for further assistance.
AA
BB
HAMPTONBAY.COM
Publicidad
