Bosch 0603B01200 Manual Original página 28

OBJ_BUCH-880-001.book Page 27 Tuesday, March 24, 2009 4:39 PM
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter
Noise/Vibration Information
Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 93 dB(A);
Sound power level 106 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 25.03.2009
Bosch Power Tools
Assembly
Avoid unintentional starting of the ma-
mm 190
chine. During assembly and for all work on
mm 1.4–2.5
the machine, the power plug must not be
connected to the mains supply.
mm 30
Delivery Scope
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Chop and mitre saw with mounted saw blade
– Dust bag 18
– Quick-action clamp 14
– Allen key 22
– Batteries (2x, size AAA, 1.5 V)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
Mounting to a Working Surface
(see figure A)
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– Fasten the power tool with suitable screw
fasteners to the working surface. The holes
12 serve for this purpose.
English | 27
Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
1 609 929 S46 | (24.3.09)