Publicidad
Idiomas disponibles
Idiomas disponibles
CHAPTER -4: FOOD STORAGE GUIDANCE
ERROR TYPE
ERROR TYPE
Sr
Sr – Set
value blink
Freezer comp. Not
on the
Cold enough
freezer set
value screen
Sr – Set
value Blink
"Refrigerator comp.
on the cooler
Not Cold enough"
set value
screen
Sr – Set
value blink
"not cold enough
on the
freezer and
cooler set
value screen
Sr – Set
value blink
Refrigerator comp.
on the cooler
set value
screen
"Low voltage
"--"
Check Warnings;
If your fridge is not operating;
• Is there a power failure?
• Is the plug connected to the socket correctly?
• Is the fuse of the socket to which the plug is connected or the main fuse blown?
• Is there any failure at the socket? To check this, plug your refrigerator into a known working socket.
If your fridge is not cooling enough;
• Is the temperature adjustment right?
• Is the door of your fridge opened frequently and left open for a long while?
• Is the door of fridge closed properly?
• Did you put a dish or food on your fridge so that it contacts the rear wall of your fridge so as to prevent the air
circulation?
• Is your fridge filled excessively?
• Is there adequate distance between your fridge and the rear and side walls?
• Is the ambient temperature within the range of values specified in the operating manual?
If the food in your refrigerator compartment is over cooled
• Is the temperature adjustment right?
• Are there many food recently put inside the freezer compartment? If so, your fridge may over cool the food
inside the refrigerator compartment as it will operate longer to cool these food.
If your fridge is operating too loudly;
To maintain the set cooling level, compressor may be activated from time to time. Noises from your fridge at this time
are normal and due to its function. When the required cooling level is reached, noises will be decreased automatically.
If the noises persist;
• Is your appliance stable? Are the legs adjusted?
Some parts have stopped
"Failure
working or there is a failure
Warning"
in the cooling process
This warning will be seen
especially after a long term
Ideal temperature for Ref.
Compartment is +4
you see this warning your
foods is at risk of spoiling.
This is a combination of
"not cool enough" error for
Warning"
both of the compartments.
The foods starts to freeze
because the temperature
too Cold
When the power supply
goes lower than 170 V,
Warning"
the appliance goes into a
WHY
power failure
C. If
o
is too low.
steady position.
EN -13-
REMEDY
Contact the Sharp help desk as soon as
possible.
1. Do not freeze the foods that have
thawed and use it in a short time period.
2. Set the freezer temperature to colder
values or set the super freeze, until
the compartment achieves a normal
temperature.
3. Do not put in fresh food until this
warning is off.
1. Set the refrigerator temperature to
colder values or set the super cooling
mode until the compartment achieves a
normal temperature.
2. Do not open the door frequently until
this warning is removed.
You will see this failure when first starting
the appliance. It will switch off after
the compartments achieves a normal
temperature
1. Check if the "Super cooling mode"
is on
2. Decrease the refrigerator temperature
values
This not a failure. This prevents any
damage to the compressor. This warning
will go off after the voltage achieves the
required level
Publicidad
