Uline S-12782 Instrucciones De Montaje página 2

1. Square up the shell (A) with numbered flaps facing up.
Fold in flaps 1, 2, 3 and 4 in that order. Push down flap 4
until it locks under flap 1. (See Figure 1)
Figure 1
2. Turn the shell upright. Fold in flaps 5 and 6; then fold
in flaps 7 and 8 to lock 5 and 6 into place.
(See Figure 2)
Figure 2
3. Push the pad (B) into the bottom of the shell.
(See Figure 3)
Figure 3
PAGE 2 OF 9
4
2
3
1
A
8
6
5
7
B
ASSEMBLY
4. Place the rectangular partitions (C) and (D) for
S-12782; (E), (F) and (G) for S-12783, in order by
height. Push the triangular partitions (H) for S-12782
and (I) for S-12783 down into the slots until the
"locking cut" is fully seated and the partition bottoms
are even. (See Figure 4)
Figure 4
5. Slide the open channels (J) over the rectangular
partitions; then slide the closed channels (K) over
the triangular partitions. (See Figure 5)
K
Figure 5
Locking Cuts
0523 IS-12782
J