Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Conditions for the installation location.
• Good ventilation is required around the appliance to dissipate the heat properly and to guarantee
efficient cooling operation at low power consumption. Enough clearance is necessary.
-
Gap to the back approx. 50～70 mm, to the side walls and above the appliance each
approx. min. 100 mm;
-
Place the appliance so that the appliance door can open without being impeded.
• Only install at a location with an ambient temperature suitable for the climate class of the
appliance. The climate class can be found under "Technical Data" and on the rating label located
in the interior or on the appliance rear.
• Place the appliance on a steady and safe surface. If the appliance is not horizontally leveled,
adjust the feet accordingly.
• Avoid the installation:
-
Near heaters, next to a stove, direct sunlight or any other heat sources;
-
At locations with high humidity (e.g. outdoors, bathroom), as metal parts would be
susceptible to corrosion under such circumstances;
-
Near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.), in rooms which
may have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.
LEVELING THE APPLIANCE
Slight unevenness in the floor can be leveled out using the front feet.
Check whether the appliance is leveled horizontally. If the appliance is not in balance, the feet must
be adjusted.
ELECTRICAL CONNECTION
WARNING:
• The installation to the mains supply must conform to the local standards and regulations.
• Improper connection may cause to an electric shock!
• Do not modify the appliance plug. If the plug does not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
WARNING:
• The accessibility of the power plug must be ensured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the specifications on the rating label before
connecting.
• Connect the mains cable to a properly installed and earthed wall outlet.
• If the plug after installation is not accessible, a corresponding disconnect device must be
available to meet the relevant safety regulations.
33
Publicidad
