Publicidad
Idiomas disponibles
Idiomas disponibles
TIPS FOR ENERGY SAVING
• Disconnect the appliance from the power supply if it isn't in use.
• Do not install the appliance near stoves, heaters or other heat sources. In case of higher ambient
temperatures, the compressor will run more frequently and longer.
• Ensure enough ventilation at the bottom and rear side. Never block ventilation openings.
• Place all shelves in their original position.
• Adjust the temperature not colder than necessary.
• Allow warm food to cool before placing it in the appliance.
• Open the appliance door only as necessary.
• Defrost the unit regularly (depending on the model).
• Switch on the lighting only if necessary.
• The seal of the appliance door must be completely intact, so that the door closes properly.
CLEANING AND MAINTENANCE
WARNING:
• Always disconnect the appliance from the power supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appliance; moisture could enter electrical
components. Risk of electric shock! Hot steam could damage the plastic parts.
• The unit must be dry before restarting operation.
CAUTION:
• Do not use a wire brush or other sharp, abrasive items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
CLEANING THE APPLIANCE INCLUDING INTERIOR
To keep dirt and germs at bay, clean the appliance regularly!
• First clear out the contents of the appliance and store it in a cool place. Remove all moving parts
such as shelves.
• Clean the interior of the appliance, the exterior surfaces and the accessories with lukewarm
water and a mild cleaning agent; or with a clean, damp microfiber cloth without cleaning agent.
• Clean the thaw water discharge channel / opening carefully e.g. with a pipe cleaner (depending
on the model).
• After everything has dried thoroughly, you can put the appliance back into operation.
• Depending on the model: At least once a year, wipe off the dust that has accumulated on the
rear wall of the unit and on the condenser (metal grille). Use a soft brush or a vacuum cleaner
for this purpose.
37
Publicidad
