MaxxHome 20552 Manual De Usuario página 14

All the above instructions for model 20552 and 22215 (above) also apply to model 21979.
This model is fitted with a 24hr timer which has 96 segments around its circumference, each segment
being equivalent to 15 minutes of time. With the aid of this timer it is possible to preset the time and
duration of the period(s) that it is desired the heater will operate, in any 24hr period.
Timer Operation
The centre of the timer has a 3 position slide switch.
In the central position (denoted by the clock symbol) the timer will switch the heater on and off at
times set by the segments, (see setting the timer, below).
The position denoted by the "T", is a timer override position. The timer will continue to run but power will
be fed continuously to the heater. This enables the heater to be on all the time if required.
In the position denoted by the "O", the timer continues to run but no power is fed to the heater.
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
Rotate the outer ring of the timer in a clockwise direction until the current time is lined up with the
arrow pointer, i.e. if the time the timer is being set is 8 Pm, rotate the outer ring until the number 20 is in
line with the arrow pointer.
Set the time the heater is required to run by pulling the segments around the outer ring forward
appropriate to the running period (s) required.
When set, the heater will operate each day during the times programmed. Note, the heater must
always be plugged into a power socket, the element switches must be in the "on" position and the
thermostat must be suitably set to ensure the heater will come on.
If the heater is required to run continuously the slide switch on the timer should be set to the "T"
position.
If it is subsequently required to revert back to timer operation, the slide switch on the timer should be
set to the central (clock) position.
Note: When using in timer mode, due consideration should be give to fact that the heater may come
on whilst unattended.
CLEAN THE HEATER
Always disconnect the heater from the socket and let it cool down before cleaning.
Clean the outside of the stove by wiping it with a damp cloth and wiping with a dry cloth.
Do not use cleaning agents or abrasives and do not allow water to enter the heater.
STORING THE HEATER
When the stove is not used for a long time, it should be protected from dust and stored in a clean,
dry place.
14