Makita DCO180 Manual De Instrucciones página 9

4
2
3
► 1 . Thumb screw 2. Circular guide 3. Shoe 4. Loosen
5. Tighten
To adjust the cutting depth, loose the thumb screw and
then slide the shoe with the circular guide. After the
proper adjustment, tighten the thumb screw securely.
Using circular guide
3
2
► 1 . Knob 2. Tighten 3. Loosen
Loosen the knob, and adjust its position in accordance
with the size of the circle to be cut. (The hole dimen-
sions to be cut are indicated on the side of the circular
guide as a general guideline.) After completion of the
adjustment, tighten the knob securely.
► 1 . Knob
Install the end of the knob into the center of the circle to
be cut, and proceed to cut in a clockwise direction.
1
5
1
1
Vacuum cover (optional accessory)
To perform cleaner operations, use the vacuum cover and
connect the tool to Makita vacuum cleaner or dust collector.
2
► 1 . Thumb screw 2. Vacuum cover
Loosen the thumb screw and remove the shoe. Attach the
vacuum cover, and fasten it securely with the thumb screw.
The circular guide (optional accessory) can be installed
on the vacuum cover.
2
► 1 . Tool 2. Vacuum cover 3. Hose 28 4. Hose for
vacuum cleaner 5. Vacuum cleaner
Connect the hose of a vacuum cleaner/dust collector to
the vacuum cover. When connecting to Makita vacuum
cleaner, use an optional hose 28 mm (1-1/8") in inner
diameter.
2
► 1 . Tool 2. Vacuum cover 3. Hose 28 4. Dust
collector
When connecting to Makita dust collector, connect the
hose for the dust collector directly to the dust nozzle.
9 ENGLISH
1
5
1
3
4
1
4
3