Network
Adjusting network settings
Preparing the required items
The following items are required to set up the system to connect
wirelessly to the Internet.
• A broadband Internet connection via a device such as a DSL or
cable modem (connection of multiple devices may require
additional hardware)
• An access point or wireless router
• Settings information for the access point (SSID, WEP key, WPA key)
Hints
• SSID, WEP key, and WPA key are types of security information that are
required when connecting to an access point.
• When connecting to the Internet wirelessly, signal interference may occur
depending on the usage condition of the wireless network devices. If Internet
data transfer speed is decreased or the wireless controller does not function
properly, use a commercially available Ethernet cable to connect to the
Internet.
• Depending on the access point in use, you may need the MAC address for
your system when connecting to the Internet. You can fi nd the MAC address
for the system by going to
Information".
• User is responsible for Internet service fees.
Setting up the Internet connection
Internet connection settings vary according to the network
environment and the devices in use. The following procedure
describes a typical setup.
26
(Settings)
(System Settings)
1
Check that an Ethernet cable is not connected to the system.
2
Select
(Network Settings)
Settings" under
press the
button.
When a message stating that the Internet connection will be terminated is
displayed, select "Yes", and then press the
3
Select "Easy", and then press the
"System
Easy
Basic settings are set automatically.
You can manually enter detailed settings information. For
Custom
information on settings, refer to the instructions supplied
by the Internet service provider or with the network device.
"Internet Connection
(Settings) in the home menu, and then
button.
button.