Warnings And Safety Instructions - Hitachi Koki Tanaka TEA-500 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Warnings and safety instructions

Sure that anyone operating this machine has read and fully
understands this manual and it's content. Failure to follow all
safety instructions can result in serious injury or death.
Operator safety
• Always wear a safety face shield or goggles.
• Always wear heavy, long pants, boots and gloves. Do not wear
loose clothing, jewelry, short pants, sandals or go barefoot.
Secure hair so it is above shoulder length.
• Do not operate this unit / machine when you are tired, ill or under
the influence of alcohol, drugs or medication.
• Never let a child or inexperienced person operate the machine.
• Wear hearing protection. Pay attention to your surroundings.
Be aware of any bystanders who may be signaling a problem.
Remove safety equipment immediately upon shutting off engine.
• Wear head protection.
• Never start or run the engine inside a closed room or building.
Breathing exhaust fumes can kill.
• Keep handles free of oil and fuel.
• Keep hands away from drilling equipment.
• Do not grab or hold the unit by the drilling equipment.
• When the unit is turned off, make sure the drilling attachment has
stopped before the unit is set down.
• When operation is prolonged, take a break from time to time so
that you may avoid possible whitefinger disease which is caused
by vibration.
• Be sure to check all fasteners on the machine to ensure that
nothing can come loose during operation.
• Be sure that the area you intend to dig is free of any obstacles
and obstructions. Some items may be buried beneath the
surface, such as electric wiring, water lines, etc. If you have
doubts about their location-consult your local utility experts.
• This auger is designed to bore through earth. Never attempt to
bore through any solid objects such as wood, rock or metal.
• Never alter or replace the pin securing the auger bit to the power
head. Using anything other than the original pin can result in
injury.
• This model is designed to accept an auger bit with a maximum
diameter of 12 inches. Never attempt to use a larger bit with this
machine.
• Prior to starting be sure that both operators are in a position to
firmly grasp both handles and are able to gain secure footing.
Never operate on steep inclines where the potential to fall is
increased.
• Holes created by this machine can be dangerous to others. Never
leave a hole unattended where it may create a safety hazard.
WARNING!
Antivibration systems do not guarantee that you will not
sustain whitefinger disease or carpal tunnel syndrome.
Therefore, continual and regular users should monitor closely
the condition of their hands and fingers. If any of the above
symptoms appear, seek medical advice immediately.
WARNING!
If you are using any medical electric/electronic devices such
as a pacemaker, consult your physician as well as the device
manufacturer prior to operating any power equipment.
Unit / machine safety
• Inspect the entire unit/machine before each use. Replace
damaged parts. Check for fuel leaks and make sure all fasteners
are in place and securely tightened.
• Replace parts that are cracked, chipped or damaged in any way
before using the unit/machine.
• Keep others away when making carburetor adjustments.
• Use only accessories as recommended for this unit/machine by
the manufacturer.
WARNING!
Never modify the unit/machine in any way. Do not use your
unit/machine for any job except that for which it is intended.
Fuel safety
• Mix and pour fuel outdoors and where there are no sparks or
flames.
• Use a container approved for fuel.
• Do not smoke or allow smoking near fuel or the unit/machine or
while using the unit/machine.
• Wipe up all fuel spills before starting engine.
• Move at least 3 m away from fueling site before starting engine.
• Stop engine before removing fuel cap.
• Empty the fuel tank before storing the unit/machine. It is
recommended that the fuel be emptied after each use. If fuel is
left in the tank, store so fuel will not leak.
• Store unit/machine and fuel in area where fuel vapors cannot
reach sparks or open flames from water heaters, electric motors
or switches, furnaces. etc.
WARNING!
Fuel is easy to ignite or get explosion or inhale fumes, so that
pay special attention when handling or filling fuel.
G
B
GB-3

Publicidad

Tabla de contenido
loading

Tabla de contenido