Publicidad
Idiomas disponibles
Idiomas disponibles
Now web the lower section
Figure 18: Webbing lower section.
3. Lift the in-feed table and put it in the upper position (A).
4. Unwind the film from the lower unwind roll.
5. Pull the film forward until the end reaches above the nip and stick it to the film from the upper
section.
6. Lower the in-feed table.
7. Set nip height to about the thickness of the leader panel.
8. Push the films with a leader panel (C) into the nip using slow mode (B).
9. When the leader panel is completely out of the nip, lower the top roller to the full closed position
(nip height = 0).
10. Use foot switch to start process then switch to normal run with the forward button when ready.
5.4 Processes and settings
5.4.1 General
For up to date process information with SEAL® materials go to www.sealgraphics.com.
5.4.2 Pre-coating panels
This process is used to coat boards (substrates) with a pressure sensitive mounting film onto which
images can be mounted. This process can also be used to create a carrier board (Sled). In this case a
film with adhesive on both sides with a release liner is used.
Note: The mounting film is usually provided with one release liner. Place the film in the upper
section and web it as if it has no release liner (see 5.3.2 for reference).
1. Place the roll of mounting film on the shaft of the upper unwind position.
2. Remove Image Guide.
3. Raise top roll to full open position.
4. Pull film through nip and attach to out-feed table.
5. Insert a leader panel into nip of the same material, thickness and width of panels to be processed.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
19
Publicidad
