Miniland Solar-Dinamo Auto Manual Del Usuario página 15

ASSEMBLY
Place the gearbox (2) over the body (1),
align four rims (21) to the guides (25),
and push gearbox (1) to the end. In
doing so, the shafts (22) will align to the
holes (101), the gearbox (2) will abut
inward vertical surface of the body (1).
For the following step 3-6, it is important to note that each
wheel hub is required to be fitted with the correct shaft, thus for
easy fitting each hub is clearly marked. Wheel hubs marked
with "1" can be fully inserted to the front shaft, and wheel hubs
marked with "2" can be fully inserted to the back shaft.
3
2
Slip four tires (3) on four hubs (4). Make
sure that they are fitted together properly.
Otherwise the car cannot move smoothly.
Fix one front wheel hub on front shaft
(6). Tighten the screw (5) to fasten.
Note that only the correct wheel hub
can be fully inserted to shafts (6)
Slip the front shaft (6) on front bracket (7). Fix
another front wheel hub in the front shaft
(6). Then fasten the screw (5) to
fix them tightly. Again note
that only the correct wheel
hub can be fully inserted to
shafts (6)
15