SpeedEPart Agri-Fab 45-0456 Manual Del Usuario página 4

2. Slide the bag arm channels (4) into the sweeper
housing as shown in figure 2. Secure them to the
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). Tighten bolt until snug. Do
not overtighten.
3. Secure each bag arm channel to the side of the
sweeper housing with a plastic wing nut (31) installed
onto the bolt assembled in step 1. See figure 3.
4. Insert a pivot rod retainer (30) down into the end of
each bag arm channel. See figure 3.
5. Install a compression spring (32) into the bottom of
each of the pivot rod retainers to secure them to the
bag arm channels. See figure 3.
31
15
4
21
FIGure 2
30
32
FIGure 3
6. Attach the drawbar (14) to the sweeper by fastening
a drawbar bracket (8) above and below the drawbar
using three 5/16" x 2-1/2" hex bolts (15) and 5/16"
nylock nuts (21). See figure 4.
14
8
21
7. Lock the drawbar into position by inserting a 3/8" x 3"
hitch pin (20) into the center hole and securing it with
a 3/32" cotter pin (19). See figure 5.
8. Attach the hitch bracket (12) and straight hitch bracket
(13) to the drawbar using two 5/16" x 2-1/2" hex bolts
(15) and 5/16" nylock nuts (21). See figure 6.
9. Assemble a 3/8" x 3" hitch pin (35) and two 3/4"
spacers (22) to the hitch brackets. Secure them in
place with a 3/32" hair cotter pin (18). See figure 6.
15
35
12
22
13
21
18
4
15
8
20
19
FIGure 4
FIGure 5
FIGure 6