monzana 100126 Manual De Instrucciones página 6

INTENDED USE
The safe is suitable for safely storing items. Use the product only for the purpose it is intended for.
The manufacturer accepts no liability for damage caused by unintended use. Any modification to
the product may negatively impact safety, cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product.
After unpacking, please check the product for damage and to ensure it is complete. Subsequent
claims cannot be accepted.
COMMISSIONING
To open the safe:
c) Enter the code (the original factory code is 1, 5, 9) and press "*" or "＃" until the green light is
on. Turn the key or knob within 5 seconds (in case of a rotary handle, please turn this first),
and then pull it to open the safe.
d) Every time you press the button, the yellow light will light up and you will hear a beep. This
confirms that the microprocessor has accepted your input. If the yellow light stays on
continuously and the beep does not stop, your input is incorrect. After three incorrect inputs,
you cannot enter any code for 20 seconds. After another 3 incorrect attempts, the input is
blocked for 5 minutes.
Locking the safe:
Close the door and turn the key or knob (in case of a rotary handle, please bring this into the
vertical position).
Setting and changing the user code:
c) Make sure that the safe door is open. Press the Reset key. When the yellow light lights up,
you must enter the desired user code (3-8 digits). Press "*" or "＃" to complete the input.
d) If the yellow light illuminates continuously and you can hear the beep continuously, the
entered code is incorrect. To change the user code, you must repeat the steps.
Manually opening the safe:
If you have forgotten your code, please remove the cover next to the rotary knob and insert the
key into the keyhole. Turn it to the left to move the knob or rotary handle. This will open the door.
Under no circumstances put the key in the safe!
Changing the batteries: When the red and green light is on, you need to change the battery.
Check the battery is correctly positioned before closing the door.
DISPOSAL
At the end of your item's long service life, please dispose of the valuable raw materials properly
so that proper recycling can take place. If you are not sure how best to proceed, the local waste
disposal companies or recycling centres will be happy to help.
CORRECT DISPOSAL OF THIS PRODUCT
Never dispose of electronic appliances as household waste! Take defective or discarded appliances
to recycling centres.
6 www.DEUBAXXL.de