Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGING THE DIRECTION OF THE DOOR
● Power supply: Connect to DC 12V/24V, AC 100-240V (using an adapter) or solar
(12-50V) power supply.
● Display screen: When the fridge is powered on, the buzzer will make a long sound, the
display will show for two seconds and the appliance will enter standby mode.
● Power on/off: Press
● Temperature setting: Press + or- the temperature setting, which will be saved automati-
cally. Note: The current temperature of the compartment is what is displayed. It will take
a while to reach the set temperature. Setting range: -20-20°C (-4-68°F).
● Cooling mode: When on, press
saving mode). Factory setting is MAX.
● Battery protection mode: When on, hold
Press
again to select the protection mode H (High), M (Medium) and L (Low). Factory
setting is H.
● The voltage is theoretical, it may differ in different scenarios.
● H should be set when the product is connected to the car power. M or L should be set
when it is connected to a portable or back-up battery.
The directions of the door can be changed. Follow the steps
below if necessary:
Taking off the door:
Open the door at a 90° angle and take off the door vertically.
Door installation:
Align the door shaft with the compartment hole on the other
side and insert it.
to switch on and hold
to switch to MAX (fast cooling) and ECO (energy
for three seconds to switch off.
for three seconds until the screen flashes.
Publicidad
