Publicidad
Idiomas disponibles
Idiomas disponibles
3. FIRST INSTALLATION
Once the device is installed, before you can use it you need to power it and wait for the LED to flash two flashes.
Power the receiver, the LED performs two flashes.
Once the LED is turned off, the receiver is ready to be used.
4. LEARNING OF A TRANSMITTER
The B.RO MINI is compatible with 433MHz transmitters. Before learning a new remote control make sure that the type of transmit-
ted code is compatible with that of the receiver in use and move close to the receiver itself.
Make sure the receiver is powered and ready to use (LED off).
Once press the learning button, the LED lights up.
Press the button of the transmitter you want to store.
The LED will flash two times to confirm the correct storage of the remote control.
Repeat the procedure for each transmitter you want to store.
Warning: After 10 seconds of inactivity the device automatically exits the programming menu.
Attention: The receiver stores only one button per transmitter. If a second key is stored, it will replace the previously
stored key.
KEY:
4 - English
R
= LED Off;
= LED On Fixed;
= flashing LED
6-1620073M - rev.5 - 27/02/2023
2 x
R
2 x
Publicidad
