Publicidad
Idiomas disponibles
Idiomas disponibles
5. RELAY OUTPUT PROGRAMMING
The receiver has three modes in which you can program the operation of the relay output (Normally Open Contact).
In TOGGLE mode, the relay changes its status each time the transmitter button is pressed.
1.
2.
In IMMEDIATE mode, the relay output remains closed until the transmitter button is pressed.
3.
In TIMED mode, from the moment the transmitter button is pressed, the relay output remains closed for a programmable
time of 1 to 120 seconds.
Make sure the receiver is powered and ready to use (LED off).
Hold down the learning button for at least 2 seconds, but less than 10.
When you see the LED flash slowly release the button.
The led will run 5 flashes to confirm the correct programming.
Make sure the receiver is powered and ready to use (LED off).
Press and hold the learning button for at least 10 seconds.
When you see the LED flash quickly release the button.
Press and hold the learning button for 5 seconds.
The led will run 5 flashes to confirm the correct programming.
Make sure the receiver is powered and ready to use (LED off).
Press and hold the learning button for at least 10 seconds.
When you see the LED flash quickly release the button.
Press the learning button a number of times equal to the seconds for which you want to program that
the contact of the relay remains closed (minimum 1, maximum 120).
At each press of the button the led flashes.
Example: 10 press of key = the output remains closed for 10 seconds.
Press and hold the learning button for 5 seconds.
The led will run 5 flashes to confirm the correct programming.
KEY:
6-1620073M - rev.5 - 27/02/2022
TOGGLE MODE OF USE
IMMEDIATE USE MODE (DEFAULT)
TIMING MODE OF USE
R
= LED Off;
= LED On Fixed;
SLOW
Example
= flashing LED
5 x
FAST
5 x
FAST
10 x
5 x
English - 5
Publicidad
