Publicidad
Idiomas disponibles
Idiomas disponibles
• Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
•
Some dust created by power sanding,
WARNING
sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to
filter out microscopic particles.
SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
UL Listing for Canada and U.S.
SPECIFICATIONS
Cat. No. ..................................................... 2525-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
No Load RPM ................................... 5000 - 27,500
Collet ...............................................................1/8"*
Max Accessory Diameter ....................... 2" / 55 mm
Recommended Ambient
Operating Temperature ......................0°F to 125°F
* Also accepts standard collet sizes 1/32", 1/16", 3/32" (sold
separately)
FUNCTIONAL DESCRIPTION
4
3
2
1
1. Collet nut
2. Nose collar
3. LED
4. Spindle lock
5. ON/OFF switch
6. Handle
7. Fuel gauge
8. Speed selector
7
8
6
5
Spindle
Collet
Nose collar
Collet nut
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Only use accessories with Maximum Safe Operat-
ing Speed rated at least equal to the maximum
speed marked on the power tool. This speed is
based on the strength of the accessory, allowing
for a reasonable measure of safety. It is not
meant to imply a best or most efficient operat-
ing speed. Do not exceed the Maximum Safe
Operating Speed.
To reduce the risk of injury, always clean man-
drels before inserting them into the collet and
securely tighten the collet nut and. Otherwise
the high-speed rotation of the tool could force
the accessory to fly out of the collet.
Everyone in the area must wear protective cloth-
ing and safety goggles or face shields. Damaged
accessories may fly apart with considerable
force, causing potential for serious injury.
Installing Accessories
1. WARNING! Remove battery to avoid starting the tool.
2. To remove the nose collar, twist to the UNLOCK
position and pull away from the tool. The nose
collar can be used for toolless accessory changing.
3. Remove dust and debris from the
collet, collet nut, and accessory
shank.
4. Insert the collet into the spindle.
5. Loosely screw the collet nut onto
the spindle.
6. Insert the accessory shank into
the collet at least 3/4".
5
Publicidad
