Publicidad
Idiomas disponibles
Idiomas disponibles
Removable Belt Clip (Fig. 6)
Your tool is equipped with a removable belt clip
that can be positioned on the left side of the
tool for convenient transport.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib of the belt clip with the threaded
hole on the base of the tool.
c. Insert the screw and securely tighten the
screw with a screwdriver.
Remove the belt clip from the tool:
d. Remove the battery pack from the tool.
e. Use a screwdriver to loosen the screw that
attaches the belt clip to the impact driver.
f. Remove the screw and the belt clip.
Install and Remove Bits
Your tool is equipped with a quick-change collet, making bit installation and removal very
easy.
Lock the variable-speed trigger switch "OFF" by placing the direction-of-rotation selector in the
center position.
To install the bit:
Pull the locking sleeve forward, insert the bit as far as it will go into the collet, and release the
locking sleeve to lock the bit. (Fig. 7)
To remove the bit:
Pull the locking sleeve forward. Pull the bit from the collet and release the sleeve.
Fig. 7
Locking Sleeve
NOTICE: Use only bits with power grooves; other bits can be used with a universal bit holder
that has power groove. Do not use bits that have a damaged shank.
WARNING
14
Use protective gloves when removing the bit from the tool, or first
allow the bit to cool down. The bit may be hot after prolonged use.
Fig. 6
Publicidad
