Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING
Service
WARNING
cause serious hazard.
Service Center or Authorized SKIL Service Station.
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch selectors must be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep it away from corrosive
agents.
TROUBLE SHOOTING
Problem
Tool does not work.
Bit cannot be
installed.
16
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
We recommend that all tool service be performed by a SKIL Factory
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air.
wear safety goggles when cleaning tools with compressed air.
Certain cleaning agents and solvents damage plastic parts.
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery pack is depleted.
2. Tool is over-loaded.
3. Battery pack is over-
temperature
4. Battery pack is not installed
properly.
5. Burned out switch.
Bit does not fit the sleeve.
Remedy
1. Charge the battery.
2. Release the variable-speed trigger
switch and try again.
3. Turn off the impact driver and cool
the battery pack under air flow.
4. Confirm that the battery is locked
and secured to the tool.
5. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
Use a suitable bit or adapter.
Always
Some of
Publicidad
