Denon TU-245 Instrucciones De Operación página 9

The broadcast is received in monaural regardless of the
mode of the FM broadcast. The reception mode should be
set to "MANUAL" when there is noisy reception of stereo
broadcasts (which are indicated by the lighting of "AUTO")
and also when the signal is weak.
During tuning, the reception frequency is tuned up or down
only when the TUNING/PRESET control knob is operated.
REAR PANEL
!4
FM antenna terminals
(ANTENNA TERMINAL FM)
75 Ω/ohm coaxial cables can be connected to these
terminals. For the connection procedure, see the section
"CONNECTIONS". (Refer to Page 6.)
!5
AM antenna terminals
(ANTENNA TERMINAL AM/
Connect the included AM loop antenna. (Refer to Page 6 for
connections.)
Connect with this terminal when a AM outdoor antenna is
used.
DISPLAY
q !3
PRESET
q
16-segment display
This displays the frequency, station name, program type,
etc.
w
RDS indicator
This lights when receiving RDS broadcasts, and flashes
during the RDS search.
e
EON indicator
This lights when receiving EON information.
r
TA indicator
This lights when the EON TA button is pressed and when a
traffic announcement is being received.
t
TP indicator
This lights when receiving a station broadcasting traffic
announcements and flashes during the TP search operation.
y
RT indicator
This lights when the RT button is pressed.
u
PTY indicator
This flashes during the PTY search operation.
!3
!6
!7
)
w e t u i o !0
r y
RDS EON TA TP RT PTY TUNED STEREO AUTO
i
o
!0
!1
!2
!3
Preset channel button (1 ~ 8)
Use these when presetting and recalling stations. Also use
these with the SHIFT/PTY button to use a total of 40 preset
channels, A (1 ~ 8), B (1 ~ 8), ... E (1 ~ 8).
Output terminals (OUTPUT)
Connect these to the TUNER input terminals on the pre-
main amplifier.
AC Inlet
Connect the included power supply cord here.
!1 !2
RF ATT MEMO CH
TUNED indicator
This lights when a station is properly tuned in.
STEREO indicator
This lights when receiving stereo broadcasts. It remains off
when receiving AM (MW) broadcasts.
AUTO indicator
This indicates the tuning mode. It lights in the auto mode,
and remains off in the manual mode.
MEMO indicator
This flashes for 10 seconds when the MEMORY button
is pressed, and flashes during the auto preset memory
operation.
CH indicator
This lights when the preset channel number is displayed,
and flashes during the auto preset memory operation and
memory operation.
TUNING/PRESET indicator
This displays the operation mode of TUNING/PRESET
u
control .
ENGLISH
y
9