Makita 9237C Manual De Instrucciones página 6

Removing or installing head cover
1
► 1. Head cover 2. Screw 3. Screwdriver
To remove the head cover, perform the following steps:
1. Remove the screw on the head cover with
screwdriver.
2. Remove the head cover as shown in the figure.
To install the head cover, perform the above steps in
reverse.
Installing loop handle
CAUTION:
• Always be sure that the loop handle is installed
securely before operation.
1
2
► 1. Protrusion of loop handle 2. Matching hole in
gear housing
Always install the loop handle on the tool before opera-
tion. Hold the tool's switch handle and the loop handle
firmly with both hands during operation.
Install the loop handle so that its protrusion will fit into
the matching hole in the gear housing.
Install the bolts and tighten them with the hex wrench.
The loop handle can be installed in two different direc-
tions as shown in the figures whichever is convenient
for your work.
3
2
► 1. Loop handle 2. Hex wrench 3. Bolt
► 1. Loop handle 2. Hex wrench 3. Bolt
Installing or removing the wool pad
(optional accessory)
For tools which are equipped with a backing pad.
► 1. Wool pad 2. Sleeve 18 3. Backing pad 4. Spindle
5. Shaft lock
To install the wool pad, first remove all dirt or foreign
matter from the backing pad. Press the shaft lock and
screw the backing pad onto the spindle. Insert the
sleeve 18 into the center hole of the backing pad.
Using the sleeve 18 as a positioning guide, install the
wool pad on the backing pad with the sleeve 18 inserted
through the center hole of the wool pad. Then remove
the sleeve 18 from the backing pad.
To remove the wool pad, just tear it off the backing pad.
Then unscrew the backing pad while pressing the shaft
lock.
6 ENGLISH
1
2
3
1
2
3
1
2
3
4
5