Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL CONNECTION
EN
WARNING: To avoid personal injury or damage, be sure to turn off the power to the main fuse box before wiring.
L: AC IN 220-240V
N: AC IN 220-240V
: Yellow/Green
Bracket
Receiver place:
ASSEMBLING
Make sure you have all the components before beginning installation.
To prevent damage, attach themotor to the support rod on a soft surface or use the polystyrene contained
in the package.
1/ Open the carton box and take out the fan (fig. 1).
2/ Assemble the support plate on the ceiling using two or
more screw anchors and appropriate washers. Attention:
the provided screw are for wood joist and concrete ceiling.
(fig. 2). Loose the bolt and screws on the support rod, Slide
down the haning ball, insert the electric cables and safety
wire coming out from the support rod.( (fig. 2).
3/ Insert the support rod through the upper cap and lower
cap.
4/ Fix the support rod to the motor using the pin and pin's
nut. (fig. 3)
5/ Hang the fan on the hook on the support plate and
connect the electrical cable coming from the ceiling to the
screw terminal placed on the top of support rod, make sure
the receiver must be insert into support plate(see Remote
control connnection).
6/ Adjust the safety wire, and fix with provided screw on the
wood joist or ceiling. Slide upwards the upper capand fix it
with the screw. ( fig. 4)
7/ Slide downwards the lower cap; it must be supported by
the motor. Fix it with the screw. (fig. 4)
10
Yellow/Green
Yellow/Green
Yellow/Green
LIGHT L
LIGHT L
LIGHT N
LIGHT N
Remote
control
8/ Center the slots on the blades with the heads of the
blades fixing screws and slide the blades so that the head of
the screws are positioned at the end of slot. (fig. 5)
9/ Tighten the screw. (fig. 6)
10/ Remove the screws from connect plate of the motor,
please organize all the wires carefully into connect plate.
Assemble and align the holes on the back of LED light
to the three screws on the connect plate of motor. (fig. 7)
11/ Then tighten the three screws on the LED plate, connect
the connector together with the motor wire, please make
sure the light kit can't be moved after tighten the screws.
(fig. 8)
12/ Place the lamp shade on the fan. (fig. 9)
LEVANTE DC
fig.
fig.
1
2
fig.
fig.
3
4
fig.
5
fig.
7
fig.
9
ASSEMBLING
Safety wire
fig.
6
fig.
8
fig.
10
EN
11
Publicidad
