Publicidad
Idiomas disponibles
Idiomas disponibles
Plug power cord into any 110-125V standard wall outlet.
The red LED in the tri-tap will light indicating the outlets
are energized. If the indicator does not light, check
power source. Plug up to three electrical appliances
into the tri-tap outlet. Pull cord to approximate desired
length. Continue pulling the cord out slowly. When a
clicking sound is heard, stop pulling the cord. The cord
is now locked in place and is ready for use. To retract,
pull the cord out slowly until the clicking sound stops.
The cord is now unlocked and ready to retract fully.
CAUTION! To avoid possible injury. Do not allow
the cord to fly unrestricted back into the reel.
Guide the cord back into the reel by hand to
control retraction speed.
WARNING! Unplug unit before performing any
maintenance.
• Remove dirt and grime as soon as it accumulates.
Use a soft, damp cloth and a mild soap, if needed.
PAGE 4 OF 12
INSTALLATION CONTINUED
MAINTENANCE
• Be sure not to get the electrical plug wet.
• Never submerge any part of the Cord reel in any
1-800-295-5510
uline.com
NOTE: Outlet is un-switched and energized at
all time. Do not overload.
NOTE: The reset button for the circuit breaker
is located on the side of tri-tap. If unit is
overloaded, circuit breaker will trip (black
reset button will pop out). Remove overload,
wait two minutes, then reset by pressing black
button.
solution.
0623 IH-5644
Publicidad
