AEG BLP18 Traducción Del Manual Original página 6

EN ORIGINAL INSTRUCTIONS
SPECIFIED CONDITIONS OF USE
The panel light is intended for general illumination. Do not use the
product in wet conditions.
Do not use the product for any other purpose.
WARNING! Read all safety warnings, instructions,
illustrations and specifi cations provided with the product.
Failure to follow all instructions listed in this user manual may result
in electric shock, fi re, and/or serious injury.
PANEL LIGHT SAFETY WARNINGS
The light source contained in this luminaire shall only be replaced
by the manufacturer, his service agent, or a similar qualifi ed
person.
Do not direct the light beam at persons or animals, and do not stare
into the light beam yourself (not even from a distance). Staring into
the light beam may result in serious injury or vision loss.
Use the product only with the recommended battery pack and
charger. Any attempt to use another battery pack will cause
damage to the product and could possibly explode, cause a fi re, or
cause personal injury.
Do not disassemble the product.
If wrapped or in contact with fabrics, the lens can produce suffi cient
heat to melt some fabrics. To avoid serious personal injury, never
allow the lens to come in contact with anything.
Do not place the product or battery pack near fi re or heat. This will
reduce the risk of explosion and possible injury.
To reduce the risk of injury or damage, avoid contact with any hot
surface.
Do not store the product in a damp or wet location, or in a location
where the temperature may reach or exceed 40°C (104°F). For
example, inside sheds, vehicles, or metal buildings in the summer.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING! To reduce the risk of fi re, personal injury, and
product damage due to a short circuit, never immerse your tool,
battery pack, or charger in fl uid or allow fl uid to fl ow inside them.
Corrosive or conductive fl uids, such as seawater, certain industrial
chemicals, and bleach or bleach containing products, etc., can
cause a short circuit.
Do not dispose of used battery packs in the household refuse or
by burning them. AEG distributors off er to retrieve old batteries to
protect our environment.
Battery packs that have not been used for some time should be
recharged before use.
For an optimum lifetime, the battery packs have to be fully charged
after use.
For battery pack storage longer than 30 days:
• Store the battery pack where the temperature is below 27°C and
away from moisture.
• Store the battery packs in a 30% - 50% charged condition.
• Every six months of storage, charge the pack as normal.
Battery pack protection
The battery pack has overload protection that protects it from being
overloaded and helps to ensure long life.
Under extreme stress, the battery electronics turn off the product
automatically. To restart, turn the product off and then on again.
If the product does not start up again, the battery pack may have
discharged completely. Recharge the battery pack.
Transporting lithium batteries
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance with
local, national, and international provisions and regulations.
• Batteries can be transported by road without further requirement.
• Commercial transport of lithium-ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
6
When transporting batteries:
• Ensure that the battery contact terminals are protected and
insulated to prevent short circuit.
• Ensure that the battery pack is secured against movement within
the packaging.
• Do not transport batteries that are cracked or leaking.
• Check with the forwarding company for further advice.
KNOW YOUR PRODUCT
See page 2.
1. Battery pack
2. Head adjustment knob
3. Hook
4. Carrying handle
5. On/off button
6. LED panels
7. Base
MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to various types of commercial solvents and may
be damaged by their use. Use clean cloths to remove dirt, carbon
dust, etc.
Use only AEG accessories and spare parts. Should components
that have not been described need to be replaced, contact one
of our AEG service agents (see our list of guarantee/service
addresses).
If needed, an exploded view of the product can be ordered. State
the product type and the serial number printed on the label,
and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364
Winnenden, Germany.
SYMBOLS
Read the instructions carefully before starting the
product.
CAUTION! WARNING! DANGER!
Rated maximum ambient temperature
Class III protection
Do not stare at the operating light source.
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose of waste batteries, waste electrical
and electronic equipment as unsorted municipal
waste.
Waste batteries and waste electrical and electronic
equipment must be collected separately.
Waste batteries, waste accumulators, and light
sources have to be removed from the equipment.
Check with your local authority or retailer for recycling
advice and collection point.
According to local regulations, retailers may have an
obligation to take back waste batteries and waste
electrical and electronic equipment free of charge.
Your contribution to the reuse and recycling of
waste batteries and waste electrical and electronic
equipment helps to reduce the demand of raw
materials.