Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Suggestions
No Power
If the LED on your dash remote is not on, check the "Power" light on the chassis of The Epicenter. If the "Power" light is
on, you will want to check to make sure that the cable connecting the remote to the chassis is not pinched or discon-
nected. If the "Power" light is off check to make sure that the power wire and remote turn on wires are connected or a
fuse has not blown.
No Bass Restoration
When your system is playing and yet you don't hear any difference in the sound, try turning the knob clockwise. If you
still don't hear any affect, then you need to make sure that you have The Epicenter in the right part of the signal chain. It
must be installed BEFORE any crossovers in the system.
Note: If you are using a source unit with a built in crossover or processor, you must run a full range output to The Epicenter's
inputs.
Sounds Distorted
Should your system sound distorted or your speakers are moving way too much, you should decrease the amount of
bass restoration by turning the dash control knob counter-clockwise. You should also raise the PFM frequency or lower
the setting on your Bass Output control.
Still Distorted
Adjust the Para Bass controls by turning the sweep control clockwise to raise the center frequency. If you still have
distortion, you should power down The Epicenter, remove the cover and change the Bass Output setting to a lower
position (i.e. 2.5 volts).
EN-16
Publicidad
