Publicidad
DISPLAY
When laser is powered on, LCD monitor on rear panel shows the current operating standalone mode or DMX
address of DMX mode. Press MODE to choose following modes as follows:
Display
AUTO
SOUD
d***
SLAV
OFF
DMX MODE
This mode allows you to use universal DMX-512 console to operate.
1. Install the units in a suitable position.
2. Use standard XLR cable to connect your units together via the XLR connector on the rear of the
units. For longer cable we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit using the display.
4. Turn on all units. Use DMX console to control your units.
DMX signal
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the
DMX input of the first unit in a DMX chain. If you wish to connect a DMX controller with other XLR outputs
you will need to use adapter cables.
1 = Shield
2 = Signal (-)
3 = Signal (+)
Connect the DMX output of the first unit in a DMX chain with the DMX input of the next unit in the chain.
Always connect the output of one unit with the input of the next unit until all units are connected. If you use a
controller with 5 pin DMX connection you will need to use a 5 pin to 3 pin adapter.
Caution at the unit, the DMX cable has to be terminated with a terminator. Solder a 120 Ohm
resistor between Signal (-) and Signal (+) into a 3-pin XLR connector and plug this into the
DMX output of the last unit in the chain.
Press "MODE" to choose functions.
In "d***" mode, press "UP" or "DOWN" to select DMX address.
Press "ENTER" to save the current working mode or DMX address.
Working mode
Auto running mode
Sound active mode
DMX mode
Slave mode
Off
Description
Auto running program
Sound active running
Turn off the device
Publicidad
