Hilti X-PT 5 Manual De Instrucciones página 8

3.2 Assembling the tubular sections and grip section
Screw the tubular sections and grip section together.
3.3 Opening the retaining bar
Open the retaining bar by releasing the screw knob.
3.4 Fitting the tool 5
Fit the tool.
3.5 Securing the tool 6
Secure the tool with the retaining bar and tighten the screw knob.
3.6 Position of the trigger lever
Note that the trigger lever must be positioned in front of the trigger.
4 Operation
4.1 Loading and using the tool
The instructions contained in the operating instructions for the tool, concerning loading and use of the tool,
must be observed.
4.2 Fastening accessories
Note
Never press the tool against the working surface at an angle. Always work at right angles to the
surface into which the fasteners are to be driven.
Hold the tool with the extension at right angles to the surface into which the fasteners are to be driven.
Press the nose of the tool against the surface.
Pull the trigger.
4.3 Grip section 10
The grip section can be rotated at any time to bring it into a comfortable working position.
4.4 Reloading 11
Load the tool after lowering the pole tool.
4.5 Do not swing the tool down
Note
Do not swing the tool down while holding the pole at its lower end.
5 Disassembly
Disassemble the tool following the assembly steps in the reverse order.
2 English
Printed: 30.03.2017 | Doc-Nr: PUB / 5341687 / 000 / 00
4
7
8
9
12
3